In order to avoid unnecessary accidents, the following safety systems must be strictly observed when the electric scraper is working.

Before working, the driver must carefully check the condition of each component of the electric scraper and the working environment and then operate according to the operating procedures.

When inspecting, repairing, and refueling, all parts of the machine must be in completely stationary and stable condition.

Due to the limitations of underground working conditions, it is strictly prohibited to stand in front of or in front of the electric scraper at the work site, or to park or stack other machine items on the transport path.

When the machine's brake fails, it should be stopped immediately for inspection and maintenance to keep the brake in good condition.

It is strictly prohibited to stand people under the arm when lifting the moving arm of the electric scraper, and the overhaul must be reliably supported by the sleeper before proceeding.

Non-drivers are not allowed to pull the control handle or operate the machine at will.

Always check the tightness of the shaft end fastening screws and tire screws to prevent accidents.

After parking, the power must be cut off and check whether the parking brake is reliable. The bucket must be on the ground. When parking on a slope, the four wheels must be padded with stones.

Disassembly and inspection should be carried out after the replacement wheel has been deflated.

When inspecting, repairing, or refueling, the machine must be stopped, the power supply must be cut off, and the bucket must be dropped to the ground.